ADC ADTEMP II Digital Thermometer Model 413B-00 User Manual

1. Introducere

Thank you for choosing the ADC ADTEMP II Digital Thermometer, Model 413B-00. This compact and reliable thermometer is designed for accurate temperature measurement. Please read this manual thoroughly before use to ensure proper operation, maintenance, and to achieve the most accurate results.

2. Produs terminatview

The image shows the ADC ADTEMP II Digital Thermometer, a white, pen-shaped device with a digital display showing '98.6 °F'. It is accompanied by its clear plastic protective case, which has the 'ADC AMERICAN DIAGNOSTIC CORPORATION' logo printed on it. The thermometer features a blue cap at the end opposite the probe.

Caracteristici cheie:

• Accurate digital temperature readings.
• Compact size, under 5 inches long, for easy handling and storage.
• Auto-off function to conserve battery life.
• Clear plastic case included for sanitary storage.
• Measurement range: 90°F - 109.9°F (32°C - 43.9°C).

Ce este inclus:

• ADC ADTEMP II Digital Thermometer
• Protective scabbard carry case

3. Configurare și pregătire

1. Inspectați dispozitivul: Before first use, carefully inspect the thermometer for any damage. Do not use if damaged.
2. Clean the Thermometer: Before and after each use, clean the thermometer probe as described in the "Maintenance and Cleaning" section.
3. Pornire: Press the power button (usually located near the display) to turn on the thermometer. A short beep will sound, and the display will show all segments briefly, followed by the last measured temperature or "Lo" if the ambient temperature is below 90°F (32°C).
4. Select Measurement Unit (if applicable): Some models allow switching between Fahrenheit (°F) and Celsius (°C). Refer to the device's specific instructions for this function, usually by holding the power button during startup.

4. Instrucțiuni de utilizare

The ADTEMP II thermometer can be used for oral, rectal, or axillary (underarm) temperature measurements. Always ensure the probe is clean before use.

4.1 Oral Measurement (Recommended for Adults and Older Children)

1. Place the probe tip under the tongue as close to the heat pocket as possible.
2. Close your mouth and hold the thermometer in place with your lips and fingers. Avoid biting the thermometer.
3. Hold the thermometer until a series of beeps indicates the measurement is complete (approximately 60 seconds).
4. Read the temperature displayed.

4.2 Rectal Measurement (Recommended for Infants and Young Children)

1. Apply a water-soluble lubricant to the probe tip.
2. Gently insert the probe tip no more than 1/2 inch (1.3 cm) into the rectum. Do not force the thermometer.
3. Hold the thermometer in place until a series of beeps indicates the measurement is complete (approximately 60 seconds).
4. Read the temperature displayed.

4.3 Axillary (Underarm) Measurement (Less Accurate, Use as a Screening Method)

1. Așezați vârful sondei în centrul axilei.
2. Ensure the arm is pressed firmly against the body to hold the thermometer in place.
3. Hold the thermometer until a series of beeps indicates the measurement is complete (approximately 5-10 minutes). Note: Axillary measurements take longer and are generally less accurate than oral or rectal methods.
4. Read the temperature displayed.

4.4 După măsurare

• Turn off the thermometer by pressing the power button, or it will automatically shut off after approximately 10 minutes of inactivity to conserve battery.
• Clean the thermometer as per the "Maintenance and Cleaning" section.
• Păstrați termometrul în carcasa lui de protecție.

5. Întreținere și curățare

5.1 Curățarea termometrului

It is crucial to clean and disinfect the thermometer before and after each use to prevent cross-contamination.

1. Wipe the probe tip and shaft with a soft cloth dampened with 70% isopropyl alcohol or a mild soap and water solution.
2. Rinse the probe tip with cool water (do not immerse the entire thermometer).
3. Uscați bine cu o cârpă curată și moale.
4. Do not use harsh detergents, abrasive cleaners, or immerse the entire thermometer in water or cleaning solutions.

5.2 Înlocuirea bateriei

The ADTEMP II thermometer uses a button cell battery. When the battery symbol appears on the display, it's time to replace the battery.

1. Localizați capacul compartimentului bateriei, de obicei la capătul opus sondei.
2. Carefully remove the cover (a small screwdriver may be needed).
3. Remove the old battery and insert a new one of the same type (e.g., LR41 or SR41), ensuring correct polarity (+/-).
4. Puneți bine capacul compartimentului bateriei.
5. Aruncați bateriile vechi conform reglementărilor locale.

5.3 Depozitare

• Depozitați termometrul în carcasa sa de protecție atunci când nu îl utilizați.
• A se păstra într-un loc răcoros și uscat, ferit de lumina directă a soarelui și de temperaturi extreme.
• A nu se lăsa la îndemâna copiilor.

6. Depanare

7. Specificații

• Model: 413B-00
• Interval de măsurare: 32°C - 43.9°C
• Tip de afișare: Digital
• Sursa de alimentare: Battery Powered (Button Cell)
• Oprire automată: Da, pentru a conserva durata de viață a bateriei
• Componente incluse: Scabbard carry case
• Material: Plastic
• Culoare: Alb
• Dimensiuni: Aproximativ 4.69 cm x 3.03 cm x 0.71 cm (ambalat)
• Greutate: Aproximativ 0.01 uncii (ambalat)
• Producător: ADC (American Diagnostic Corporation)

8. Garanție și asistență

ADC (American Diagnostic Corporation) products are manufactured to high standards. For specific warranty information, please refer to the warranty card included with your product or visit the official ADC website. For technical support, replacement parts, or service inquiries, please contact ADC customer service directly.

Informații de contact: Please refer to the packaging or the official ADC website pentru cele mai recente date de contact.